Sensors & Accessories

SUITS: Haltech iC-7 and Microtech ECUs INCLUDES: 1 x HT-130049 Can Adaptor Loom NOTES: Use with Microtech CAN Hub for direct plug and play  

SUITS: Haltech IC-7 Dash, WBC 1, WBC 2 and Link Plug-in ECUs INCLUDES: 1 x CAN Adaptor Loom (DTM-4 to JST 5-pin) - Suits Link PlugIn ECUs NOTES: Us...

SUITS: Haltech iC-7 Dash, WB1, WB2 and Link Wire-in ECUs (Storm, Extreme, Fury, Thunder, Force GDI) INCLUDES: 1 x CAN Adaptor Loom (DTM-4 to 6-pin ...

SUITS: Haltech IC-7 Dash, WB1, WB2, and aftermarket ECUs using the AMP Superseal 1.0 Series Connector INCLUDES: 1 x HT-130046 CAN Adaptor Loom (DTM...

LENGTH: 3000mm / 120in SUITS: Haltech iC-7 Dash INCLUDES: Cables and Fuse  

SUITS: Mazda Miata (MX-5) NB 1.8L Non VCT or VCT (00-04) 1.8L Factory Turbo SE (Aus), Mazdaspeed (04-05 USA) with 3-plug 3-row factory ECU. Manual ...

LENGTH: 3000mm / 120in SUITS: Haltech iC-7 Dash INCLUDES: Cables and Fuse

SUITS: Elite Pro Plugin ECU and WB1/WB2 INCLUDES: Bosch LSU 4.9 sensor with Factory calibration resistor connector (not a Deutsch DT-6 connector)  

LENGTH: 1.2M (4ft) INCLUDES: Dual Channel, CAN Wideband Controller, 2 x 4.9LSU Sensor, CAN Cable (4'/1200mm), Power Supply Cable, 2 x Weld-on Bung,...

PLUG (CANF) Soldering is required for assembly

BOOST CONTROL SOLENOID Four Port4 x 1/8 NPT ports

BOOST CONTROL SOLENOID Three Port3 x 1/8 NPT ports

CABLE (CANPCB) Required to add CAN / Serial communications

COOLANT TEMPERATURE SENSOR (NTC1-8) Complete with plug and terminals. Aluminium and steel, weld in, mounting bosses available

AIR TEMP SENSOR (IAT1-8) 1/8" NPT complete with plug and terminals. Aluminium and steel, weld in, mounting bosses available

ETHANOL CONTENT SENSOR - #ECS Ethanol Content Sensor measures the ratio of ethanol to petrol in a flex fuel vehicle. Comes with AN-6 fitting. ...

3 BAR MAP SENSOR (MAP3) MAP Sensor capable of reading of reading up to 3 Bar (2 Bar of boost).Includes 3 Bar MAP Sensor and plugs and pins.

LINK 4 BAR MAP SENSOR (MAP4) MAP Sensor capable of reading up to 4 Bar (3 Bar of boost).Includes 4 Bar MAP Sensor and plugs and pins.

CAN LAMBDA Link’s CAN Lambda is an easy to use CAN module that provides digital wideband sensor control via CAN bus and is compatible with lead...

TUNING CABLE (CUSB) USB Tuning Cable - ECU to USB

KNOCK SENSOR (KNS) Donut style, 8mm hole, with matching connector